r/canadaguns • u/AHangryBeaver • 13d ago

Fix my gun TM22 Issues

So, I will say it’s gotten “better” after putting about 350 rounds but my current issues are:

Not so much failure to eject but failure to chamber a round/cycle a round. - I’ve found loading 8/9 rounds per magazine instead of 10 makes a huge difference however I still get these squibs? No bullet stuck in the barrel but it just explodes in the chamber.

The Tommy enterprise Mag sleeves were a bit of an issue, they don’t quite seat properly without a love tap and yes they are the proper fitment and secured tightly. The current video attached actually broke the mag sleeve.

I’ll post a photo in a comment below showing what’s happening to the shells when it just jams them rather than propels chambering the round. No idea if it’s just the ammo (Aguila interceptor) or if it’s too high of spring tension on the magazine or if I have an actual issue with the action.

89 Upvotes

97% Upvoted

75 comments sorted by

View all comments

2

u/EnggyAlex Alex's Homebrew 12d ago

Does this happen without mag sleeve? I feel like its case are damaged during feeding if you get constant f2e and shits like this

2

u/AHangryBeaver 12d ago

It does happen without the mag sleeve when the mags are loaded 10/10 rounds. Once I went down to 8 or 9 rounds I didn’t have that issue however the OOBD blew off the rear part of the mag which I think might have been causing further issues with the cartridges not chambering correctly

(All 3 of my mags now look like this)

1

u/EnggyAlex Alex's Homebrew 12d ago

Ok I think you got unlucky with the mags, its sounds like your mag feeding angle is not right and the rounds got deformed when its chambering, on extreme case your round would stuck to the chamber and your bolt came in and set off the primer. 22 oobd is not going to fuck the gunitself up at very least

Another possibility is the barrel sits too far into the receiver so the nose of the bullet hits top of the chamber, which would take some shims to fix.

https://www.reddit.com/r/canadaguns/s/oQHK5JT9hJ

I had a similar situation with rf223