r/canadaguns • u/CurlyWurly61 • May 07 '26

Misc These don't look half bad

Post image

If I were to buy one, I was curious, could I change out thay bulky stock?

188 Upvotes

95% Upvoted

112 comments sorted by

View all comments

6

u/therowdyirishman May 07 '26

Yes, you can swap out the stock and pistol grip with anything marketed for an AR. There are two main styles of buffer tube (aka receiver extension) Milspec and Commercial. Milspec is more common/preferred but Derya uses a Commerical tube. If you want to use a Milspec stock you'll need to replace the buffer tube first, which involves filing the end plate a little to accommodate it (or getting a 3D printed version). Alternatively, if you want to slim out the stock the entire cheek riser assembly can be removed which makes a big difference. Here's an example of one I kitted out. https://www.reddit.com/r/canadaguns/s/0O7WaA7DNT

Edit: I only have experience with the aluminum reciever model and that's the only one I'd recommend. So I'm not sure if my advice above refers to the polymer version.

2

u/randomnewguy9595 May 08 '26

For commercial spec tubes you can just use an airsoft stock. It's only a .22 after all

1

u/HappyCan7250 May 08 '26

If I remember right, the polymer model the buffer tube is molded into the stock and non swappable, and it too used a commercial sized tube which kinda sucks, far fewer options available. 

I do really like the new Pro stocks though. Got a 16" Pro right when they showed up, and was tempted to grab a 12" now, but I actually sort of prefer the 16" look.

1

u/TrowserShnake May 08 '26

I’ve swapped the stock off of my feather model.

You’ll need a commercial spec stock or you may get lucky with an airsoft stock.

I put an airsoft stock on mine and it works fine.