r/canadaguns • u/Remote_Mistake6291 • Apr 18 '26

Fix my gun Dlask receiver.

Has anyone built a 10/22 using a Dlask receiver? I bought one of their receivers and a Shaw barrel. There is no way the barrel is fitting in the receiver without modifications. Anyone know if they use a proprietary barrel size?

6 Upvotes

100% Upvoted

10 comments sorted by

View all comments

3

u/Disastrous-Panic-87 Apr 18 '26

My tuf-22 receiver with the Kidd match bull barrel was the same. I froze the barrel and used a rubber mallet to hammer behind the receiver while inserting the barrel. Worked out really good. Just be careful with alignment of the barrel / extractor groove because if not aligned, it'll be a pain on the butt to rotate afterwards.

Keep in mind that super tight fit is 1000x better then just a tad loose. So be careful if you sand the tenon...

Also, afterwards, the tacksol V-block doest miracles to prevent barrel droop. (Tried OEM, adjustable V-blocks, etc) Tacsol V-block has always been my go to in 10-22 builds.