r/canadaguns • u/EnggyAlex Alex's Homebrew • 4d ago

Misc Fine i'll release this monstrosity

So quite a few people actually prefer the factory charging handle location on the tm22 and asked me about this abomination i made a few months ago so here it is🤦

49 Upvotes

94% Upvoted

17 comments sorted by

View all comments

Show parent comments

1

u/Status_Ticket5044 2d ago

Hey Alex! Good morning. Do you have a thorough vid or post on your trigger mod? I'm now into paying attention to lousy triggers and my TM-22 is the worst of the lot. A long, grungy drag with no real defined trigger release point. I understand it's a work in progress.

2

u/EnggyAlex Alex's Homebrew 2d ago

so the trigger design is done and proven, however the laser cutting place I went to make the proprietary trigger linkage bar for the lighter trigger did a very lousy job so I have to use a file to hand fit and try them on a rifle for each of them. I'm getting really proficient at stripping down the gun now but its still a major pain in the ass........

1

u/Status_Ticket5044 2d ago

So $0.07 each material cost and $30 to QC. Sigh. No one ever said being a mad scientist was gonna be easy.

2

u/EnggyAlex Alex's Homebrew 2d ago

Essentially ya