r/canadaguns • u/EnggyAlex Alex's Homebrew • 4d ago

Misc Fine i'll release this monstrosity

So quite a few people actually prefer the factory charging handle location on the tm22 and asked me about this abomination i made a few months ago so here it is🤦

45 Upvotes

92% Upvoted

17 comments sorted by

View all comments

3

u/scottsuplol 3d ago

I’d like a size in the middle between yours and the factory. Have also looks at some of the conversions to put the pull back charging handle like on most AR’s

2

u/Status_Ticket5044 3d ago

If your TM-22 has an aluminum receiver, Alex's works well. There's a half dozen reasons why Alex's is better than Tommy's. Neither work well with plastic receivers.

2

u/scottsuplol 3d ago

I just picked up the pro so most likely will slap one on that. Turning it into my cope gun honestly

1

u/Status_Ticket5044 2d ago

Rule #1... When tearing it completely down to thoroughly clean every 1000 rounds or so (swab it out after each use), remember the order of the 3 screws holding the top cover/rail down. 3 different lengths. Longest at the rear, shortest to the front. 10-15 in/lbs max and use blue Loctite. You're tightening steel bolts into aluminum threads.