r/canadaguns • u/AHangryBeaver • 5d ago
Fix my gun Soaking in solvent
I’ve been recommended to soak my bolt/firing pin of my TM22 in solvent to completely dissolve any grease etc from the factory and then add a high quality silicone lubricant to it to see if it fixes the feed issues etc.
Is it recommended to clean it just with a field stripping or should I entirely disassemble the gun and clean every last nook and cranny?
I’ve reached out to Derya in terms of warranty as it had 4 or 5 OOB detonations as well as failure to feed.
Known issues: Putting 10/10 rounds in the magazine. 8/10 feeds better so I assume that’s a spring tension issue.
CCI Blazers have FTF issues, Aguilla interceptors aren’t as bad however with the TE mag sleeves on, they were having the OOB issues as well as horrific FTF issues.
It hasn’t had a ton of extraction issues but there’s been a few that typically go hand in hand with the FTF
5
u/DifficultReference99 5d ago
Id really take the time to dry off the pieces, full dissasembly or blowing it off with compressed air. Ive had of guns FTF and act up when i was over accessively oiling them. I had a mossberg begin light striking because of an oily firing pin. Oil viscosity was slowing down the firibg pin.