r/canadaguns • u/habes187 • 10d ago

Gun and gear reviews Adler RF224 Read before buying

.

I’ll start off saying I’ve read tons of reviews and it’s about a 70/30 split of bad luck to good luck with them. My own experience was a bad one at the start, lots of failures to feed and failures to eject are suuuuuuper common with this gun out of the box. I’ve put over 1300 rounds through mine now and I’ve run into lots of issues for sure but overall it could be worse.

Fixes I’ve done. first step is to disassemble the internals and grab some scotch brite pads, I’ve found there is a lot of paint on the bolt especially on parts that rub and slide together so using scotch brite down to clean bare metal and oiling makes it slide much smother. Ammo is a big factor and I’ve tested lots and it’s honestly all realistically the same, but best results come from 38-40 grain. When firing I’ve also found pulling it in tight and keeping a good grip helps the recoil and the bolt cycling, being a 22 if you hold it too loose it won’t have enough power to fully cycle the bolt and pull the old shell out and eject it causing a jam. Then the newest and best option i found to prevent the failure to eject and chambering issues is to buy a compensator or some type of muzzle device. The changing in the gas flow and slowing it down a bit helps get more gas to cycle the bolt back fully and eject the rounds.

Anyway this is my first ever post and im not quite sure how to do this but i hope its helpful to some. Biggest take away is that its a 500$ gun but its a lot of fun and a great option. Doing this it has gone from 30 issues in the first 100 shots to 2 issues in the last 100. And those purely from rapid fire testing.

14 Upvotes

86% Upvoted

4 comments sorted by

View all comments

3

u/Status_Ticket5044 10d ago

Good post. I'm one of the lucky 70% that have had no issues other than it runs 0% on genuine 10/22 mags, 100% using its OEM mags, about 95% using 597s and the adapter. It is indeed a decent little range toy (that desperately needs a speed loader).

Thanks for understanding the limitations of cheap plinkers and fixing it instead of screaming at the sky and shaking your fist.