r/canadaguns • u/NoGrapefruit1213 • May 22 '26

Gun and gear reviews Ruger 10/22 archangel nomad

Gallery image

Gallery image

Gallery image

Gallery image

Gallery image

I had one of these years ago and like a fool sold it. I stumbled upon one a few weeks ago and jumped on picking it up. They are neat I’ll give them that. Bit heavy a lot of work for assembly but overall pretty cool. Fit and finish I’d give 8/10 there’s good sized gaps where the case halves fit together and the iron sights are awful. I decided to through a red dot on but the sights obstruct the view so they had to go. I modeled some filler parts and here we are. Next up I might toss my 10” barrel back on pin the folding stock and find a 36c forend the mag sleeves are printed aswell as the barrel shroud as the one it came with was almost impossible to get on/off

40 Upvotes

92% Upvoted

16 comments sorted by

View all comments

10

u/Whispersfine May 22 '26

Thought about it, pain in the ass to clean, passed.

Nice looking tho.

5

u/NoGrapefruit1213 May 22 '26

Thanks! Yeah my experience with any 10/22 is it requires minimal cleaning and most of it can be done assembled any 10/22 I have will run dirty and any ammo you put through it.

2

u/Status_Ticket5044 May 23 '26

My 10/22 is in an ATI AR22 plasti-chassis that's a pain to disassemble but 1) I figured out how much NOT to disassemble and still clean thoroughly, and 2) usually just swab everything out after use and it'll go 1500 rounds until the ejectors start to clog up.

1

u/ParanoiaDreamland May 25 '26

What are your tips for what NOT to disassemble and still clean thoroughly?

1

u/Status_Ticket5044 May 25 '26

https://youtu.be/Ihtdhj3gC6s?si=2vXkXmmASnrvRNXG Get past this guy's moaning and complaining and he has helpful advice for partial disassembly to do a full clean.

1

u/ParanoiaDreamland May 27 '26

thank you! Also, did you also have an issue with the buffer tube tabs not aligning properly with the chasis?